WSN DIY

From Neuromeka Wiki
Jump to: navigation, search


WSN + WSN DIY

1. WSN DIY SPEC

◈ Available sensor interface
• UART : 2 Set
• I2C : 1 Set
• SPI : 1 Set
• GPIO : 22 Port
◈ Line connection
◈ Power source
• Input : 5V from WSN
• Output : 3.3V, 5V

2. WSN DIY COMPONENT MAP

02 001 WSN DIY COMPONENT MAP.png


3. Product composition

◈ IGoT Hub (1EA)
◈ WSN + WSNDIY (2EA)

03 001 WSN+WSNDIY.png

◈ IGoT Hub POWER CABLE (1EA)
◈ WSN POWER CABLE & USB HEADER (2EA)
• Micro B 5Pin USB Cable
◈ LAN CABLE (1EA)
◈ Basic Sensor Kit

03 002 Basic Sensor Kit .png

• Button (1ea)
• RGB Led (1ea)
• Temperature+Humidity Sensor (SHT21+HTU21 - 1ea)
• Luminance Sensor (BH1750 - 1ea)
• Motion(PIR) Sensor (SR501 - 1ea)
• Door Sensor (SR501 - 1ea)
• RJ11 to Bare Wire (6ea)
◈ Industrial Sensor Kit (1EA)

03 003 Industrial Sensor Kit.png

• Dust sensor (PM1101 - 1ea)
• CO2 sensor (CM1001 - 1ea)
• Noise sensor (FC04 - 1ea)
• Ultrasonic sensor (SRF05 - 1ea)
• Color sensor (YL64 - 1ea)
• VOC sensor (IAQCore - 1ea)
• RFID/NFC sensor (PN532 - 1ea)
• RJ11 to Bare Wire (1ea)

4. Sensors Spec

◈ Basic Sensor Kit

04 001 Basic Sensor Kit .png

◈ Industrial Sensor Kit (1EA)

04 002 Industrial Sensor Kit.png


5. Sensors Connection

◈ Basic Sensor Kit

05 001 Basic Sensor Kit .png

◈ Industrial Sensor Kit (1EA)

05 002 Industrial Sensor Kit.png


6. NOTE

1) WSN#1 is configured for Basic Sensor Kit. WSN#2 is is configured for Industrial Sensor Kit.
Sensors should be connected to WSN with proper wiring.
You can refer to the table above(5. Sensors Connection).
2) BASIC KIT SENSORS : BUTTON, LED, TEM+HUM, LUMINANCE, DOOR, MOTION, NFC
NFC is actually included as an Industrial Sensor, but You should connect to the Basic Kit's WSN(WSN#1).
Because We don't have enough UART port.
3) INDUSTRIAL KIT SENSORS : CO2, DUST, TVOC, ULTRASONIC, NOISE, RGB
CO2 and DUST sensors can not be connected to WSN at the same time. Because We don't have enough UART port.
4) Zigbee Pairing Module
We are preparing now.